共找到 150 條與 交貨批次數量 相關的標準，共 10 頁
1.1 本標準的目的是定義統一的測試程序和測量方法，以評估農場便攜式批量混合器的混合能力。 1.2 本標準適用于混合不同顆粒大小和密度的干燥顆粒成分的批量混合器。測試應包括測量較小顆粒大小和/或較大顆粒大小的成分與一種基礎材料的混合
Test procedure measures mixing capability of portable batch mixers in agricultural fields
AS ISO 13543:2022 identically adopts ISO 13543:2016, which specifies the method for determining the mass of contained metal in a lot, based on the wet
Copper, lead, zinc and nickel sulfide concentrates — Determination of mass of contained metal in a lot
This part of ISO 801 specifies a method for determining the dryness of a lot of pulp baled in sheet form and for calculating its saleable mass
Pulps - Determination of saleable mass in lots - Part 1: Pulp baled in sheet form
This Specification covers a statistical sampling plan for lot inspection by attributes. It verifies that the customer's specified quality level (SQL
Lot Acceptance Procedure for Verifying Compliance With the Specified Quality Levels (SQL) in PPM
Sludge from urban wastewater treatment works - Liquid sludge - Sampling for the purpose of estimating the average content of a batch
A review of the nature of partial discharge in machine windings, how it can be measured under both off-line and on-line conditions, how it can
IEEE Approved Draft Guide for the Measurement of Partial Discharges in AC Electric Machinery
Pulps - Determination of saleable mass in lots - Part 3: Unitized baled (ISO 801-3:1994); German version EN ISO 801-3:1996
Ergonomic Guidelines for Small Lot Delivery Systems (Version 1)
Draft Document - Paper and board - Determination of moisture content of a lot - Oven-drying method (ISO/DIS 287:2016); German and English version prEN ISO 287:2016
Describes a method of selecting a sterilization dose to be used for radiation sterilization of a single production batch of health care products
Sterilization of health care products - Radiation sterilization - Selection of a sterilization dose for a single production batch
Scope is not provided for this standard
Copper, lead and zinc sulfide concentrates -- Determination of mass of contained metal in a lot
This Technical Report presents the sampling theory which h s resulted in the definition of the sampling plan described in ISO 8634 . The sampling
Solid fertilizers -- Derivation of a sampling plan for the evaluation of a large delivery
Sequential sampling inspection plans for percent defectives having desired operating characteristics by variables (standard deviation known)
Pulps - Determination of saleable mass in lots - Part 1: Pulp baled in sheet form (ISO 8001-1:1994)
Pulps - Determination of saleable mass in lots - Part 1: Pulp baled in sheet form (ISO 801-1:1994); German version EN ISO 801-1:1996
