共找到 150 條與 引用誤差 相關的標準，共 10 頁
ESDU 85011 treats the additional corrections to the pitot and static pressures@ registered by their sensors in unsteady flight conditions@ required
Pitot and static errors due to non-steady flight.
ESDU 85011 treats the additional corrections to the pitot and static pressures@ registered by their sensors in unsteady flight conditions@ required
Pitot and static errors due to non-steady flight
本標準規定了壓力表的基本誤差限及回差、輕敲位移、環境溫度影響等示值誤差的允許值。 本標準適用于以彈性元件為敏感元件的不同精確度等級、測量范圍的壓力表。本標準規定了儀表工作環境溫度偏離參比溫度時的示值誤差限，本標準僅適用于材料的彈性模量溫度系數"K"為0.04%/℃的儀表
Pressure gauge error table
Technical Norm for Error of Measurements and Interpretation of Data
Measuring errors and differences due to impedance inaccuracies of instruments and apparatus. Use of decoupled measuring points
本標準規定了日用陶瓷器的容積、口徑誤差、高度誤差、重量誤差、缺陷尺寸的測量方法、測量工具以及計算公式。 本方法適用于日用陶瓷器，不包括陳設藝術陶瓷制品和大型陶瓷器制品
Standard method for measurement of volume, rim diameter allowance, hight allowance, weight allowance and size of defects of domestic ceramic ware
此部分規定了一種標準方法，用于通過圓度測量確定形狀檢測設備在其位置處的測量技術性能（精度、穩定性）的變化。適合于驗收和檢查形狀測量儀器的測試一致性
Determination of the radial spindle deviation
Diese ?NORM ist in Verbindung mit ?NORM M 6775 Teil 1 für Kegelr?der mit oktoidenf?rmigem Zahnprofil gem?? ?NORM M 6730 Teile 1 bis 3 anzuwenden. Die
Accuracy of bevel gears; tolerances for shaft angle errors and common apex errors
General Rules for Error Analysis and Accuracy Evaluation of Telemetry Parameters
Grinding errors
Measurement error
本標準規定了平面度誤差檢測的術語定義、評定方法、檢測方法和數據處理方法。 本標準適用于機械產品中零件要素的平面度誤差檢測。 本標準是對GB/T 1958中平面度誤差檢測的具體規定
Measurement of departures from flatness
ESDU 86006 considers all contributions to pressure errors and the implications of the various tests needed to determine the errors in steady level
Pitot and static errors in steady level flight.
Cross References: IEC 60904-3:1989 EN 60904-3:1993 IEC 60904-10:1998 EN 60904-10:1998
Photovoltaic devices-Computation of spectral mismatch error introduced in the testing of a photovoltaic device
structural error
