共找到 150 條與 溫度校正函數 相關的標準，共 10 頁
Part 1-401: Detail specification – Sensing application – Assessment level EZ thermistorsThis detail specification is a supplementary document
Thermistors – Directly heated positive step-function temperature coefficient
Determination of flash point — Pensky-Martens closed cup method — Amendment 1: Thermometers correction
Determination and use of straight-line calibration functions
Part 1: Generic specification
Polymeric thermistors - Directly heated positive step function temperature coefficient
Part 1-1: Blank detail specification - Current limiting application
Polymeric thermistors - Directly heated positive step function temperature coefficient
Directly Heated Positive Step - Function Temperature Coefficient Thermistors - Generic Specification
此標準適用于直接加熱正溫度系數步函數熱敏電阻的應用，具體為感測應用
Thermistors - Directly heated positive step-function temperature coefficient - Part DE0001: Component specification - Sensing application - Assessment level EZ Thermistors
Cross References: IEC 60027-1:1992 IEC 60050 IEC 60062:1992 EN 60062:1993 IEC 60068-1:1988 EN 60068-1:1994 IEC 60068-2-1:1990 EN
Thermistors. Directly heated positive step-function temperature coefficient-Generic specification
Thermistors - Directly heated positive step-function temperature coefficient -- Part 1: Generic specification.
CORRECTOR, TEMPERATURE: 10511080 (NO S/S DOCUMENT)
Petroleum measurement systems - Calibration - Temperature corrections for use when calibrating volumetric proving tanks.
This International Standard specifies multiplication factors for the correction of the volume of water transferred from a primary measure to a tank
Petroleum measurement systems - Calibration - Temperature corrections for use when calibrating volumetric proving tanks
?? ? ??? ?? ???? ??? ??? ???? ?? ?? ??? ?? ????
Petroleum measurement systems-Calibration-Temperature corrections for use when calibrating volumetric proving tanks
Petroleum measurement systems－Calibration－Temperature corrections for use when calibrating volumetric proving tanks
The saturation state of calcium carbonate in water has been determined for years by use of the Langelier Index. The US Environmental Protection Agency
Journal AWWA — Temperature and Ionic Strength Corrections to the Langelier Index -- Revisited
