共找到 150 條與 相對檢測水平（RLOD） 相關的標準，共 10 頁
本文件規定了一種方法，用于在邊界材料和感興趣的測試條件下，測定土工織物或土工織物相關產品在其平面內的恒定水頭水流能力。提出了一系列標準測試條件，包括土壤約束、低水力梯度、靜置時間和一系列法向載荷
Geotextiles and geotextile-related products. Determination of water flow capacity in their plane. Performance test
本文件規定了相控陣超聲檢測(UT-PA)在壁厚為3.2 mm至8 mm的低合金鋼和/或細晶鋼焊接接頭中的允許限值，這些接頭符合ISO 5817的評估組別。這些允許限值適用于根據ISO 20601檢測到的指示
Non-destructive testing of welds - Phased array ultrasonic testing (UT-PA) for thin-walled steel components - Acceptance levels (ISO 4761:2022); German version EN ISO 4761:2022
Preparation of steel substrates before application of paints and related products – Collected information on the effect of levels of water-soluble salt contamination
Preparation of steel substrates before application of paints and related products – Collected information on the effect of levels of water-soluble salt contamination
This document specifies acceptance levels for the phased array ultrasonic testing technique (UT-PA) of full-penetration welds in low-alloy
Non-destructive testing of welds – Phased array ultrasonic testing (UT-PA) for thin-walled steel components – Acceptance levels
Geotextiles and geotextile-related products－Determination of water permeability characteristics normal to the plane, without load
SAME AS ISO 12958
Geotextiles and geotextile-related products - Determination of water flow capacity in their plane (ISO 12958:2010)
Tourism and related services - Marinas - Part 1: minimum requirements for basic service level ports
Geotextiles and geotextile-related products - Determination of water permeability characteristics normal to the plane, without load.
本文件規定了通過射線檢測在鋼、鎳、鈦及其合金對接焊縫中發現的缺陷指示的驗收等級。如果達成協議，這些驗收等級也可適用于其他類型的焊縫（如角焊縫等）或材料。 驗收等級可能與焊接標準、應用標準、規范或法規相關。本文件假設射線檢測已按照ISO 17636-1（RT-F，F=膠片）或ISO 17636-2
Non-destructive testing of welds. Acceptance levels for radiographic testing. Steel, nickel, titanium and their alloys
This document specifies acceptance levels for indications from imperfections in aluminium butt welds detected by radiographic testing. If agreed
Non - destructive testing of welds — Acceptance levels for radiographic testing Part 2 : Aluminium and its alloys
Welding - Hybrid laser-arc welding of nickel steels and nickel alloys - Quality levels in relation to defects
Geotextiles and geotextile-related products. Determination of water permeability characteristics normal to the plane, under load
Non-destructive testing of welds - Phased array ultrasonic testing (UT-PA) for thin-walled steel components - Acceptance levels
Non-destructive testing of welds - Acceptance levels for radiographic testing - Part 2: Aluminium and its alloys (ISO 10675-2:2021, Corrected version 2022-02)
