共找到 150 條與 管法蘭用非金屬平墊片 相關的標準，共 10 頁
本標準規定了鋼制管殼式換熱器用非金屬墊片的結構型式、基本參數和技術要求。 本標準適用于設計溫度高于-20℃至450℃，設計壓力不大于6.4MPa的鋼制管殼式換熱器用非金屬墊片
Non-metallic gasket for tubular heat exchanger
Flanges and their joints - Gaskets for Class-designated flanges - Part 1: Non-metallic flat gaskets with or without inserts
Dimensions and marking of gaskets for nominal pressures up to and including PN 40 and nominal sizes up to and including DN 4000
Dimensions of gaskets for flanges to BS 4504-Specification for non-metallic flat gaskets (including gaskets for flanges to BS 4772)
Flanges and their joints - Gaskets for Class designated flanges - Part 1: Non-metallic flat gaskets with or without insert
Flanges and their joints - Gaskets for class-designated flanges - Part 1: Non-metallic flat gaskets with or without inserts; German version EN 12560-1:2001 / Note: To be replaced by DIN EN 12560-1 (2023-03) (in preparation).
This practice may be used to evaluate Classification F 104 gasket materials using saturated steam and standard ASME RF
Standard Practice for Comparison of Nonmetallic Flat Gaskets in High Pressure Saturated Steam
ADOPTED_FROM:EN 12560-1:2001 This European Standard specifies the dimensions, types, designation and marking of non-metallic flat gaskets
Flanges and their joints — Gaskets for Class-designated flanges — Part 1: Non-metallic flat gaskets with or without inserts
This document specifies non-metallic flat gaskets, with or without inserts, for use with flanges in accordance with EN 1092-1, EN 1092-2, EN 1092-3
Flanges and their joints — Dimensions of gaskets for PN-designated flanges Part 1: Non-metallic flat gaskets with or without inserts
ADOPTED_FROM:EN 1514-1:1997 This European standard specifies the dimensions and marking of non-metallic flat gaskets, with or without inserts
Flanges and their joints — Dimensions of gaskets for PN-designated flanges — Part 1: Non-metallic flat gaskets with or without inserts
GB/T 29463的本部分規定了非金屬軟墊片的結構型式與尺寸。本部分適用于設計壓力為0.25 MPa~4.0 MPa,設計溫度為-20℃~350℃的管殼式熱交換器用非金屬軟墊片
Gaskets used in tube-shell heat exchangers.Part 3:Nonmetallic gaskets
Diametres for flat gaskets for pipe flanges with tongue and groove
ENGLISH
Flanges and their joints - Gaskets for Class-designated flanges - Part 1: Non-metallic flat gaskets with or without inserts.
本標準規定了管法蘭用金屬包墊片的型式、尺寸及技術要求。 本標準適用于公稱壓力PN為O.25 MPa～0.63 MPa的管法蘭用金屬包墊片
Metal clad gasket for pipe flange
Flanges and their joints - Dimensions of gaskets for Class-designated flanges - Part 1 : non-metallic flat gaskets with or without inserts
This Standard covers materials, dimensions, tolerances, and markings for metal ring-joint gaskets, spiral-wound metal gaskets, and grooved metal
Metallic Gaskets for Pipe Flanges
