共找到 150 條與 轉換因素 相關的標準，共 10 頁
Conversion factors@ units. Includes some useful data for air and water. Also sea level data for the International Standard Atmosphere
Conversion factors. (Issue 2)
Fundamental standards. Units of measurement. Conversion factors.
ESDU 81002 provides a comprehensive set of conversion factors between sets of units in common use in pump engineering@ including SI and technical
Radial@ mixed and axial-flow pumps. Conversion factors.
CONVERSION FACTORS AND LOGISTICS DATA FOR PETROLEUM PLANNING
This standardization handbook was developed by the Department of the Navy, Naval Facilities Engineering Command, in accordance with established
CONVERSION FACTORS AND LOGISTICS DATA FOR PETROLEUM PLANNING
MIL-HUBK-ZIOA, dated t6 April 19.19, has been reviewed and determined to be valid for use in acquisition
CONVERSION FACTORS AND LOGISTICS DATA FOR PETROLEUM PLANNING
The standard recommends default sets of procedures for converting specific emissions from energy-conversion plants to allow reliable and unambigious
Conversion of specific emissions during energy conversion
Tabelle di conversione di pollici (interi e frazioni) in millimetri e di millimetri in decimale di pollice. Il fattore convenzionale di equivalenza
Conversion of inches to millimetres. Equivalence factors. rule for rounding up or down. Numerical conversion tables.
Guide to Metric Conversion (Addendum Traffic Engineering Metric Conversion Factors - 1993)
Traffic Engineering Metric Conversion Factors - Addendum to the Guide to Metric Conversion@ 1993
3.1 ASTM requires the use of SI units in all its
Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres
1.1 This practice provides units and factors useful for members of the air pollution and meteorological communities. 1.2 This practice
Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis Atmospheres
1.1 This practice provides units and factors useful for members of the air pollution and meteorological communities. 1.2 This practice is used
Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres
INTRODUCTION This Item presents conversion factors between sets of units in common use in pump engineering. It may be used with the other Items
RADIAL@ MIXED AND AXIAL-FLOW PUMPS. CONVERSION FACTORS
本標準規定了硅中間隙氧的轉換因子指南。本標準適用于在室溫下測試電阻率大于0.1 Ω·cm的n型硅單晶和電阻率大于0.5 Ω·cm的p型硅單晶中間隙氧含量
Guide to conversion factors for interstitial oxygen in silicon
