ASTM D5856-15
使用剛性壁壓縮模式磁導率計測量多孔材料液壓導電率的標準試驗方法

Standard Test Method for Measurement of Hydraulic Conductivity of Porous Material Using a Rigid-Wall, Compaction-Mold Permeameter

預覽 ASTM D5856-15前三頁

標準號

ASTM D5856-15

發布

2015年

總頁數

9頁

發布單位

美國材料與試驗協會

當前最新

ASTM D5856-15

 

 

引用標準

ASTM D1557 ASTM D2216 ASTM D2434 ASTM D3740 ASTM D4753 ASTM D5084 ASTM D653 ASTM D698 ASTM D854 ASTM E145

適用范圍

4.1 This test method applies to one-dimensional, laminar flow of water within laboratory-compacted, porous materials such as soil.

4.2 The hydraulic conductivity of porous materials generally decreases with an increasing amount of air in the pores of the material. This test method applies to porous materials containing little or no air. The test method is designed to minimize the amount of air in the test specimen. However, this test method does not ensure complete saturation of the test specimen with water. In cases where it is essential to saturate the test specimen fully with water, the compacted specimen may be tested using Test Method D5084.

4.3 This test method applies to permeation of porous materials with water. Permeation with other liquids, such as chemical wastes, can be accomplished using procedures similar to those described in this test method. However, this test method is only intended to be used when water is the permeant liquid.

4.4 It is assumed that Darcy's law is valid and that the hydraulic conductivity is essentially unaffected by hydraulic gradient. The validity of Darcy’s law may be evaluated by measuring the hydraulic conductivity of the specimen at three hydraulic gradients; if all measured values are similar (within 258201;%), then Darcy’s law may be taken as valid. However, when the hydraulic gradient acting on a test specimen is changed, the state of stress will also change, and, if the specimen or pore fluid is compressible, the volume of the test specimen or pore fluid will change. Thus, some change in hydraulic conductivity may occur when the hydraulic gradient is altered, even in cases where Darcy’s law is valid.

4.5 One potential problem with this method of testing is the possibility that water will flow along the interface between the test specimen and the compaction/permeameter ring. The problem tends to be of minimal significance for materials that swell when exposed to water (for example, compacted, clayey soils) but can be a very serious problem for materials that might tend to shrink and pull away from the walls of the permeameter. Test Method D5084 is recommended for any material that tends to shrink when exposed to the permeant liquid.

4.6 The correlation between results obtained with this test method and the hydraulic conductivities of in-place, compacted materials has not been fully investigated. Experience has sometimes shown that flow patterns in small, laboratory-prepared test specimens do not necessarily follow the same patterns on large field scales and that hydraulic conductivities measured on small test specimens are not necessarily the same as larger-scale values. Therefore, the results should be applied to field situations with caution and by qualified personnel.

Note 1: The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D3740 are generally considered capable of competent and objective testing/sampling/inspection......

---

ASTM D5856-15 中可能用到的儀器設備

電導率儀/電導儀/鹽度計

---

專題

磁導率測試方法 磁導率的測試 雷磁電導率儀標準溶液 電導率標準溶液使用臺賬

---

ASTM D5856-15相似標準

ASTM D5856-95(2002) 使用剛性壁壓縮模式磁導率計測量多孔性材料液壓導電率的標準試驗方法 ASTM D5856-95 使用剛性壁壓縮模式磁導率計測量多孔性材料液壓導電率的標準試驗方法 ASTM D5856-95(2007) 使用剛性壁壓縮模式磁導率計測量多孔性材料液壓導電率的標準試驗方法 ASTM D5856-95(2002)e1 使用剛性壁壓縮模式磁導率計測量多孔性材料液壓導電率的標準試驗方法 GB/T 2900.4-2008 電工術語.電工合金

---

誰引用了ASTM D5856-15 更多引用

ASTM E3163-24 基于污染沉積物現場風險的糾正措施的標準指南——分析方法和試驗程序的選擇和應用

---